fault point
英 [fɔːlt pɔɪnt]
美 [fɔːlt pɔɪnt]
网络 断层数据点; 故障點
双语例句
- Less hardware decrease device fault point, so the entire system reliability increases.
硬件的简化大大减少了装置的故障点，从而提升了系统的整体可靠性。 - Main cable conductor doesn't have splice, so has good continuity and decreases possibility of fault point.
主干电缆导体无接头，连续性好，减少了故障点。 - Less impact from the fault point, the incidence can be limited to the single module while the fault of single-centralized inverter affects the entire capacity range of the PV modules connected.
l故障点的影响小，影响范围可以控制在单个模块范围内，而集中型逆变器的故障影响为整个接入的组件容量范围。 - Distance Protection Scheme for Series Compensated Lines Based on the Fault Point Identification
基于故障点位置识别的串补线路距离保护方案 - The method to check short-circuit point between parallel conductors in transformer winding by Gaussmeter and to repair fault point are introduced.
介绍了运用高斯计来探查变压器绕组内并联导线间短路点，并对故障点进行修复的方法。 - The result proves that the method can precisely locate the fault point.
结果表明反射行波分析法能准确地确定故障位置。 - The monolithic processor automatically detects each working unit of, once the fault point occurs, a communication module is started to transfer the data signal to a central computer.
单片机自动检测各工作单元，一旦出现故障点即启动通讯模块向中心计算机传输数据信号。 - The fault type and fault point can be inspected after the transformer is off line.
变压器的具体故障种类和故障处，完全可以在变压器停运后检查到。 - On the other hand, it can locate the fault point timely and resume power supply quickly.
另一方面精确故障定位系统能及时发现线路的故障点，及早地处理停电事故，保证迅速恢复供电，减少因停电造成的综合经济损失。 - No single fault point in P2P modal.
P2P系统的冗余性很好，没有单一的失败点。 - The differential equation algorithm can accurately calculate the impedance from the splitting point to the fault point.
利用分段点处电流、电压应用解微分方程算法即可较精确地计算出线路阻抗。 - It is hard to identify the reflection signal that is counted from fault point by using usual methods.
通常的方法很难识别出来自故障点的反射信号。 - Attitude of fault and upper fault point can be determined by seismic method.
在活断层探测中，地震方法不但能确定断层的产状，而且还能确定断层的上断点。 - A brief algorithm for locating the fault point for double circuit lines is presented.
介绍了一种双回线跨线故障的简洁算法。 - Secondly, will the fault point characteristic affect the traveling wave;
故障点的特性对故障行波的影响； - It introduces cable grounding fault location method and analysis. It provides fast and true method for power supply enterprise to find fault point when cable is failure that is not easy to find.
介绍了电缆接地故障定位与分析，解决了电缆发生故障不易查找故障点的问题，为生产及供电企业快速准地查找故障点提供了可以借鉴的方法。 - The characteristic of the single-phase ground is analyzed and the relationship between the current of fault point and the negative-order current of the fault line is derived.
分析了消弧线圈接地系统发生单相接地故障的特征以及故障线路负序电流分量和故障点接地电流的关系，提出了一种系统单相接地后谐振状态在线辨识的新方法。 - It introduces and analyses the fault recording and analysis system served for Datong network group. It presents several basic technological requirements of this system and gives personal opinions for its data storage and detection of the fault point.
通过对大同电网组网运行的故障记录分析系统的介绍和分析，给出了对该系统的基本技术要求，同时，对故障录波器数据的存储和故障点测距提出了建议。 - If each testing point can detect only one fault point once, two questions will be discussed.
对于每个测试点一次只能检测一个故障点，分两种情况加以讨论。 - For the simple lines, the fault point can be located accurately by analyzing feature wave on this foundation.
对结构简单的线路，在此基础上分析特征波即可准确定位； - Aiming at the difference of wave rate in overhead lines and cables, fault point seeking algorithm based on time mid-point is proposed.
针对架空线和电缆波速度不一致的问题，给出了基于时间中点的故障点搜索算法。 - The location of fault point must be determined quickly to ensure the system security and reliability of power supply.
为保证系统安全和供电可靠性，必须迅速确定故障点位置以采取处理措施。 - On the basis of symmetrical component method and linear superposition principle, the additional positive sequence network is established and the matching index on fault point is proposed. Then with this index the fault can be located by traversing searching method.
该方法首先运用对称分量法和线性叠加原理建立故障后的附加正序网络并定义了故障点的匹配指标，进而基于该指标运用遍历搜索方法寻找故障点的位置。 - Since the measurement and analysis of harmonic are preconditions to relay protection, identification of fault point and fault type, they are key works to the analysis of power systems.
谐波的分析和测量是电力系统分析和控制中的一项重要工作，是继电保护、判断故障点和故障类型等工作的重要前提。 - The developed automatic location system has achieved good results in the field experiment. It can locate single phase ground fault point, automatically and accurately.
本文研究的单相接地故障自动定位系统在现场实验的过程中取得了良好的效果，完全可以实现配电网单相接地故障的自动、准确定位。 - The application of traveling wave location device provides effective methods for the fast and accurate search of fault point, reducing the economic loss caused by power outages.
行波测距装置的应用为故障点的快速、准确查找提供了行之有效的方法，减少了因停电造成的经济损失。 - By this method, it can realize the fault point quickly and isolate the fault accurately.
通过该方法可以迅速的检测出故障点，以实现对配电网线路故障的快速准确隔离，保证其安全性，减少国民经济损失。 - Short-circuit faults of power system are generally non-metallic, and there is transition resistance at the fault point.
电力系统中的短路故障一般都不是金属性的，而是在短路点存在过渡电阻。 - Therefore, how to locate the fault point quickly and accurately is particularly important.
因此，如何迅速、准确地判断和定位故障点，显得特别重要。